Pro Assembly Instructions

Pro Extreme, Pro Lite & Pro Pole Assembly Guide

⚠️ CRITICAL: Do NOT use power tools during the assembly process. Hand tools only. Snug all screws but do not over tighten.

Tools Required

• Back Panel Extreme: 1/8" Allen wrench
• Hinge Tensioner: 2.5mm Allen wrench
• Switch Panel, LED's & SAE (Extreme & Lite): Phillips head screwdriver
• Pole Holder (Extreme & Lite): 5/32" Allen wrench & 7/16" socket/wrench
• Docking Plate Cleats: 3/16" Allen wrench
• Docking Plate Peg (Extreme & Lite): 1/8" Allen wrench

Drill Bit Sizes

• Pole Holder: 1/4"
• LED Lights: 1/4" (wire), 1/8" (mounting screws)
• Docking Plate Peg: 7/32"

Pro Pole Transducer Configuration

The Pro Pole is compatible with the following fish finder manufacturers. Each requires specific bolt/washer/nut arrangements:

Refer to your specific transducer manual for exact mounting specifications.

Assembly Videos

Watch our step-by-step assembly videos for detailed visual instructions:

Assembly Tips

• Lay out all hardware before beginning assembly
• Double-check tool sizes before starting
• Hand-tighten all screws to avoid stripping or damage
• Test all components after installation
• Watch the assembly videos above for visual guidance

Questions? Contact our support team for assistance.