Accessory Installation
Note: Do NOT use power tools during the assembly process. Hand tools only. Snug all screws but do not over tighten.
Tools required:
Philips head screwdriver,
10mm wrench or socket,
12mm wrench or deep well socket,
3mm Allen Wrench provided
The Fish Armor shuttle was designed for ease of assembly. Follow these simple instructions and be on your way.
Effortless Clam Puck Installation Guide
Clam Puck
Step #1: Locate each set of two holes on the right side of your shuttle as you face it (refer to the picture). Punch the holes open and install your clam puck using the provided screws and nuts.
Installing the SAE Charge Port on Your Shuttle
Charge Port
Step #1: Locate your SAE cutout on the left side of your shuttle. Cut the wrap and remove the cutout plug. Initiating the removal might require pressing the edge of the hole with a hard object. Simply bend it back and forth until it's out.
Step #2: Install with 2 flat head screws and nylock nuts.
Guidelines for Installing LED Lights on Your Shuttle
Lights
Step #1: Identify each set of 3 holes. One set is situated on the upper right of the shuttle, while the other is located on the left towards the back. Open all three holes and install the lights using the provided hardware. Follow the wiring instructions provided.
